FT245RL RoHS
The FT245R is a USB to parallel FIFO interface
•
Single chip USB to parallel FIFO bidirectional data transfer interface
•
Entire USB protocol handled on the chip. No USB specific firmware programming required.
•
Fully integrated 1024 bit EEPROM storing device descriptors and FIFO I/O configiration.
•
Fully integrated USB termination resistors.
•
Fully integrated clock generation with no external crystal required
•
Data transfer rates up to 1MByte / second.
•
256 byte receive buffer and 128 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
•
FTDI’s royalty-free VCP and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
•
Unique USB FTDIChip-ID feature.
•
Configurable FIFO interface I/O pin.
Supports bus powered, self powered bus powered USB configurations.
Integrated +3.3V level converter for
Integrated level converter on FIFO
interfacing to external logic running at between
+1.8V and +5V.
True 5V/3.3V/2.8V/1.8V CMOS drive output and TTL
input.
Configurable I/O pin output drive strength.
Integrated power-on-reset circuit.
Fully integrated AVCC supply filtering
filtering required.
+3.3V to +5.25V Single Supply Operation.
Low operating and USB suspend current.
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible
USB 2.0 Full Speed compatible.
-40°C to 85°C extended operating temperaturerange.
Available in compact Pb-free 28 Pin SSOP and QFN32 packages (both RoHS compliant)